Tools needed to change car battery. How to Replace a Mercedes Benz Battery

How to Change a Car Battery: 12 Steps (with Pictures)

tools needed to change car battery

Make sure that your vehicle is in Park, with the engine shut off and the parking brake on. Tighten the clamps with your wrench, ensuring that the connections are secure. So I watched my YouTube instructional video again, wrote down the step-by-step instructions, drove over to the parts dealer, made sure they still had the battery, and got to work. . Repeat the process with the positive red terminal, gently loosening the nut and easing off the clamp. Push the red, positive lead onto the positive battery terminal and tighten the securing nut on the clamp.

Next

How to Replace a Car Starter and Solenoid

tools needed to change car battery

Power door locks are not only convenient, but also safe. If the battery is held in place with a bracket, use the pliers or wrench to take out the screws or bolts holding it into place. This article applies to the Honda Accord 1990-2002 , and Civic Del Sol 1992-2000. Connect the red to the red and black to the black. You should now be able to see the two battery terminals, which are pieces of metal protruding from the top and sometimes the side of the battery, with leads attached. Then one by one, remove all the leads and safely take out the battery.

Next

How to replace your vehicle's dead battery and the tools needed

tools needed to change car battery

Here's how to clean battery terminals. The negative battery terminal is usually black. I was going to suggest this, but someone beat me to it. If you have your new battery installed when you buy it, the shop will recycle the old one for you. If this applies, then slide the bracket out and free up the battery.

Next

How to Change a Car Battery: 12 Steps (with Pictures)

tools needed to change car battery

Do the same for the positive cable, put the bar that holds the battery down back in place and tighten the bolt. Why do you even need to worry about losing your settings? But by starting somewhere, we begin the learning process and start on the path towards mastery. Once the sunroof has fully opened, hold the button for an additional three seconds. On Mercedes vehicles that have both a system and starter battery, the latter connects first. When the battery's terminals are covered in corrosion, electricity can't flow properly, leaving you stuck in your tracks. Alternatively, you can cover the positive cable end with a cloth once it is removed to prevent any metal-to-metal contact, protecting your electrical systems and yourself from harm.

Next

How to Change a Car Battery: 12 Steps (with Pictures)

tools needed to change car battery

I felt informed with no anxiety about his arrival. Once these safety measures are in place and the tools outlined below have been collected, you are ready to remove your battery. The steps required to replace a battery on a Mercedes-Benz are straightforward, and you can complete them in less than a half an hour. Investing in a combination wrench is needed as well. Step 1 The first step is taking out the current battery. Of course, running the air-conditioning and stereo with the engine off will obviously drain the battery eventually. Reconnect both the positive and negative battery terminals, respectively.

Next

How to replace your vehicle's dead battery and the tools needed

tools needed to change car battery

Consider using zip ties or another form of restraint to keep each of the battery cables in their proper place as you take out the battery. Slide the rear of the seat under the seat backs so the seats' hooks catch the wire loops on the back frame. Aside from these tools, you will just need the right kind of replacement battery for your Mercedes. If you've already created the baking soda and water solution you need to clean your terminals, keep it handy. Remove the bolts that secure the reservoir to the fender well with a wrench. Slide the red cover off the jumper terminal to view the positive and negative posts.

Next